|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: adding a loader to 826 with 1 set of auxillary valves
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ed on September 06, 2002 at 16:59:24 from (24.46.83.100):
In Reply to: Re: Re: Re: Re: adding a loader to 826 with 1 set of auxillary valves posted by David on September 06, 2002 at 12:10:06:
My advice to you is get a friend to help or go down to the libary and take out a book on Hyd systems. Your talking about a lot of terms that go with different systems and methods. All control valves have to have an inlet and outlet but can have only one working port - their called single acting. hyd pressure will lift something and gravety will bring it down. I would stay away from any loader that is single acting for a tractor that large if you can find one - No Down Pressure. good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
