|
Tractor Talk Discussion Board |
Re: Re: Re: adding a loader to 826 with 1 set of auxillary valves
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steven@nd on September 06, 2002 at 10:16:53 from (165.234.131.231):
In Reply to: Re: Re: adding a loader to 826 with 1 set of auxillary valves posted by David on September 06, 2002 at 07:29:23:
It all depends how big of a hurry you are in. We had the loader on our 544 hooked to the tractor hydralics and it took FOREVER to raise a bale up. Put on the 21 GPM pump and now the tractor can idle and move bales fast enough. Some of the Pumps are 21 GPM and some around 11 or 12GPM. The higher volume pump has about a 2 to 3" wide center section. Steven
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
