|
Tractor Talk Discussion Board |
Re: off topic : alternative heating
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on August 24, 2002 at 20:34:26 from (64.158.132.82):
In Reply to: off topic : alternative heating posted by Slofr8 on August 24, 2002 at 09:22:23:
I would only consider a gylcol heat exchanger system for outside use. The boiler heats the anti-freeze and that heats the inside storage tank keeping the fresh water seperate from the anti-freeze. This elimates freeze ups when the unit is off and that will happen given time. If you have a basement area then I would also consider a forced air system to distribute the heat. Forced air is a more confortable heat only exceeded by direct wood heat(woodstove). The furnace plenum would use a water heat coil for heat tranfer. A typical gas forced air system is about 135* at the register, HP & Electric about 115*. That why HP units don't feel as confortable. Baseboard heaters are ok once warmed but slow to reach desired room temp. Forced air HW systems compare to gas forced air. In Arizona, HP (heat pumps) are very efficent. Just about the most effiecnt because of the short heating season where the abiment temps are 30* average at night, with 45* being the most efficent. I did a energy cost study on a heating system in 1990: 1) natural gas $.34/hr 2) HP--No strip heaters $.44/hr 3) LP $.88/hr 4) Electric $2.34/hr The above prices would vary depending on the heating units and the location and only shown for a SWAG. A Ferro cement water storage tank is very cheap to construct and really efficent on thermo loss. Don't matter where your at, dumping water into a well is a big no no. Why? If you dump contamiated water into the well it will contamiate the ground aquifer so it CAN ruin the entire water system for the next guy down stream for many miles. T_Bone
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|