Tractor Talk Discussion Board |
Re: NAA sticking clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on August 18, 2002 at 20:04:09 from (205.188.192.154):
In Reply to: NAA sticking clutch posted by craig on August 18, 2002 at 19:08:50:
Hello, I had a 1952 Chevrolet truck that did that once, and I got rid of the truck before I could fix it, but I was told that it was a leaking seal, either on the transmission or the engine. If it's on the engine, then the main bearings are probably worn, and while the tractor is in half it wouldn't hurt to drop the pan and measure the journals of the crankshaft to see if they are in specs and replace the bearings. The disk will have to be replaced because it has oil cooked into it. The pressure plate will need to be degreased if it is still useable, and the flywheel will need to be degreased. I haven't actually experienced this other than the truck, but I saw a lot of oily flywheels when I worked in a shop resurfacing flywheels. Dennis Benson
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|