|
Tractor Talk Discussion Board |
Re: Gettin her going
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on July 25, 2002 at 10:22:17 from (66.60.196.129):
In Reply to: Gettin her going posted by Jon on July 24, 2002 at 20:29:35:
Well, the 6v will be dead dead, not just run down, after 3 years??? So best to get a new one, 98% chance you'll need it anyhow. Jumping with a 12v can be done directly to the starter, but the coil & points & all will need juice, and they _won't_ like getting 12v - will last about 20 minutes in my experience before burning up (mechnic forgot the resistor on an engine swap for me...). You sure don't want to involve the 6v generator with the 12v battery. So, I'm thinking jumping with a 12v is not a good idea in your case. That works when the 6v battery is too low to turn the starter, but has enough juice to fire the plugs. You just hook up to the starter for brief periods with the 12v, not get any of the other electrical involved. Keep in mind the positive ground, however you go about it. Starting either is not good for an engine, but see if you can get it to fire with that. The carb might be quite a varnished mess, may have to clean that all out. Then again, might fire right up, it's all a crap shoot. If it's not gummed up, the gravity feed should get fuel to the carb for you. Anything with a mechanical pump would need some priming to get the float bowl full. I've heard sometimes oil seals dry out, & you'll have some engine leaks when one sits so long. Don't really know on that? --->Paul
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|