Tractor Talk Discussion Board |
Re: hard starting Long 350
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kerry on June 11, 2002 at 20:17:22 from (207.53.229.183):
In Reply to: hard starting Long 350 posted by Greg McKinney on June 11, 2002 at 13:08:37:
Have you changed the fuel filters recently? Maybe you have a little bit of air in it somewhere, if you can't get it going try bleeding it. I don't remember on the 350 but on our 445 I thin there was only one bleeder port on the injector pump. We have a 2610 now and it has 2 bleeder ports. If that doesn't do it, try bleeding it all the way up to the injectors. Normally you should only get air in it if you ran out of fuel or changed the filters, but it's a shot in the dark! Kerry
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|