Tractor Talk Discussion Board |
Re: Re: Ford Tractor Identification
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 64K10 on June 02, 2002 at 20:46:45 from (209.86.4.237):
In Reply to: Re: Ford Tractor Identification posted by Hal/WA on June 01, 2002 at 20:01:53:
Hal, Joe, UltraDog, Thanks all for your great info!!! I've worked on a number of vehicles that have been sitting for long periods, so the engine it's self wasn't a major concern. But the issues with the clutch and being in neutral are great "nuggets" of knowledge!!! Would a clutch job be something you'd do or would you advise taking it to the "shop"??? Also, you mentioned the "I&T manual"... is that a manual specific to the Fords, or generic name for "Implement and Tractor" manaul, or...??? Unfortunately I was not able to make a visit to the tractor this weekend, but hope to in the next week. Thanks again! 64K10
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|