Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: How to Kill Cat Tails


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Tim B on May 20, 2002 at 07:51:29 from (4.17.173.2):

In Reply to: How to Kill Cat Tails posted by Russ(NC) on May 20, 2002 at 03:57:10:

Russ,

I second the warning re: environmental harm, and getting into legal trouble - I am an environmental consultant in Massachusetts - regulators in these parts would just love the opportunity to "tear you a new one" (or worse) over something like that.

I don't know much about the chemicals you are using, except Roundup. The active ingredient in Roundup - glyphosate - is essentially harmless to animals. However, the surfacants (soaps) they use in it to make it stay on the plants until it dries, and after it gets wet again are very, very, very toxic to aquatic organisms. I would guess you caused a die-off of some portion of the natural community if it got into the pond.

The version of roundup intended for use in and near wetlands is Rodeo - same thing, no surfacants.

I've never tried it on cattail, but I would bet that if you use glyphosate in late summer - September, when the plants are sucking nutrients from the shoots to the roots, It will kill 90% or more of the stand. If you use it in early to mid-summer, the leaves will die, then grow right back again. Again, check out the regulations in NC re: herbicide appilcation in wetlands and waterways!


Cattails won't grow in water that is permenantly inundated with a foot or so of water. If you want to keep them out permenately, dredge the shallow portions of the pond deeper. Again, a permit is likely needed for that, but it may not be too onerus - easier than getting a permit for herbicides, I would guess.


Follow Ups:




Post A Followup

:
:

: Re: Re: How to Kill Cat Tails

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy