|
Tractor Talk Discussion Board |
Re: Chevy VORTEC Engines
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ErnieD on April 10, 2002 at 16:22:59 from (66.66.131.15):
In Reply to: Chevy VORTEC Engines posted by K-Mo on April 09, 2002 at 04:30:06:
I got a '98 Chev 4x4 and as far as I can tell the following is symptomatic for this year (and I had/got it all) bad brake rotors (dime sized divots) bad intake manifold gasket (when is an intake maniflold a routine maintenance item?) piston slap when cold. The last one frosts me. It is getting worse and GM don't care if the noise clears up in less than 5 minutes. If it takes longer they will replace the loose piston, but not hone the cylinder and will reinstall the old rings. Check out http://www.angelfire.com/tx5/gmpistonslap for the latest. The pistons are installed loose to improve internal engine friction (better mileage).
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|