Posted by cumminstinkerer on October 24, 2023 at 08:47:34 from (97.125.232.188):
In Reply to: Fuel gelling posted by Russ from MN on October 24, 2023 at 06:33:08:
Quoting Removed, click Modern View to see
Do not ever put gasoline in any diesel newer than about 1990, the injector and pump tolerances are tight enough that you run the risk of galling either the plungers/barrells or injector nozzles, and you sure as heck do not put gas into any of the common rail/huei style system or anything with any aftertreatment you will most certainly smoke injectors, pump, and aftertreatment! Really big money, BUY a good commercially available anti gel additive.
On that note also never put the red jug 911 in any common rail/HUEI style or one with aftertreatmnet same results, catastrophic failures. The only stuff available to ungel fuel that has proven to be safe for these systems is some stuff called Meltdown, I am not blowing smoke or trying to insult, just inform, I personally have seen 3 Doosan engines and one Isuzu that were totally wrecked due to the gasoline or 911 powerservice, was a very exspensive learning curve!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
