Posted by PapaBear24 on October 19, 2023 at 09:10:56 from (107.77.228.124):
If I understand the codes correctly I have a 1969 Ford 3000 industrial tractor with a 540 PTO and a 6/4 manual reversing transmission.
C5022K
9G03B
C255234
C5NN7006AR Transmission
Here is my conundrum: During an engine rebuild, I needed to change the clutch throw out bearing. In researching the transmission diagrams, this model tractor did not have a 12 inch clutch assembly, an internal return spring, a self greasing assembly and a very large throw out bearing, which is apparently obsolete. The transmission resembles either a 3500, 4000 or 5000 tractor transmission. The throw out bearing is O.D. 4 5/16; I.D. 2 1/4 and 1 5/16 wide and the hub is 4inches long. There has to be a viable solution but, most of my solutions come up a pallet of bricks to short. Would it be possible to change the size of the pressure plate and disc plate from a 12" to a more standard size? That would also come with a throw out bearing that would fit the pressure plate.
This post was edited by PapaBear24 on 10/19/2023 at 01:08 pm.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
