Posted by caterpillar guy on September 19, 2023 at 05:26:59 from (47.26.14.222):
In Reply to: Aftermarket driveline posted by Tractorcedric on September 18, 2023 at 11:37:35:
cut the shaft or tube off the front of the over running clutch and same for the tractor end only the back side there then weld some new tube on to both with them as straight as you can get it doing due diligence on that part. OR have a shop weld the pieces together. Though you already had their ability and your could not be much worse. IF you can get the shaft and tube to insert into the yokes a bit they would be pretty straight that way so that would simplify it a lot. Just make sure the yokes are phased right by aligning the koes at the same clock position at each end of the telescoping sections.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
