Posted by john in la on July 01, 2023 at 22:26:30 from (97.80.68.11):
In Reply to: Re: implosions posted by redforlife on July 01, 2023 at 21:41:23:
I would be willing to bet those tubes on the tractor tire still has the original air in them.
What makes a tube pop is the rubber can not hold the pressure inside the tube to the relation of the pressure on the outside of the tube. Lets say you fill a tube to 50 lbs inside the tube and the outside pressure is 14 lbs of our atmosphere. The tube stretches and then blows because it can not hold the outward force. But if we increase the outside force on the tube to 50 lbs it would be like the tube had 14 psi in it IE equal on inside and outside.
So the tubes on these tractors have 6000 psi of air pressure in them but the tube does not feel it because the water pressure from all sides pushing in is 6000 psi also. As long as we keep the inside pressure the same as the outside pressure the tube will hold the air just in a lot smaller space as you compress the air inside. That is until the tube rots away.
What makes something implode or explode for that matter is the structure can not hold the pressure difference from inside to outside. As long as the pressure on the inside stays the same as the outside no implosion or explosion can happen.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.