Posted by redforlife on July 02, 2023 at 09:05:43 from (174.213.212.21):
In Reply to: Re: implosions posted by DoubleO7 on July 02, 2023 at 08:41:28:
A vacuum pump (if hooked up to the valve stem), gives the air a place to go. It's actually pulled out by vacuum. In this scenerio, the air remains inside. The question is, if it's reduced to a small enough space to allow ballonage. The more I think about this, the more I'm leaning to the air is reduced to such a small place, that there wouldn't be any ballonage. Just air compressing. As you say, like a vacuum pump hooked to the valve stem, but not completely. Leaving an area that is not fully collapsed, and contains the reduced air space. By pushing on the flexible walls of the tube, it would be pushing on the external hydraulic pressure. Much like air inside a hydraulic cylinder getting smashed into a smaller bubble.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Roof Palomino - Tractor or Jeep? - by Steve Nelson. My father-in-law purchased this jeep-like lawn mower back in 1968. He says he paid $1600.00 for it, which was big bucks back then for a mower. My own father bought a VW bug the same year for the same price. Well it
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
