Posted by caterpillar guy on June 24, 2023 at 04:24:32 from (47.26.9.191):
In Reply to: How much posted by Sam Womer (PA) on June 23, 2023 at 05:17:05:
Last time I checked on brake parts for my brothers 580K they were a1000.00 per wheel so think about that for a minute. then his the hoses must be some odd sized thing since regular 1/2 inch is smaller and 3/4 is bigger. Must be a 5/8or metric junk. The pins wear and that bolt that goes through the pin in the middle breaks so we just put a bit smaller bolt in so the pin wear would not break the bolt. Around here on auction most hoes if they run go for ungodly prices and if they are or look as good as you describe add another 5-10,000 to that. I've been watching for a bout 3 years now. I'm leaning towards one of those bigger mini excavators will dig deeper and probably faster. Just don't see them for reasonable either.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
