Posted by Jim in LA on October 24, 2022 at 14:47:10 from (107.77.199.117):
I have a 2005 5105 JD that has developed a strange problem. When I turn the key on, the safety alarm emits a weak screech and the tach needle jumps around and then stops at a random spot each time. It is supposed to deflect full scale and return to zero before starting. Once the engine is started,it will indicate a higher RPM than the engine is actually running. You can really tell it when cutting and you set the throttle to show 2200RPM but the cutter is turning slower and tractor power is lower. Sometimes I can go through the start sequence 4-5 times and it will behave normally. I thoroughly cleaned all the electrical sockets and plugs this afternoon with CRC electronics cleaner and hoped that would solve the issue but it didn t. I have also made certain that both battery cables are tight. It may be a ground issue in the instrument wiring harness or an expensive instrument cluster. Also this tractor has a speed sensor that works with what looks like a gear attached to the injector pump. I have a shop manual on DVD But it does not address this issue. Any ideas?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.