Easy to install. Comes with attached 6 ft. (1.8m) input powercable and NEMA 6-50P plug
Lincoln says welders come with a 6g 50a plug. Mine is 10g and 50a plug powercable. The welder was a Christmas gift. I think this welder was purchased at sears or lowes. I'm wondering if my welder was built cheaply for the weekender welder and sold at box stores.
It works for me using a 1/8 rod, 105 amp setting, 30 amp breaker and 10g wire.
A power transformer can operate safely on less input voltage caused by IR loss.
I use a dimmer on my old battery charger. No damage to transformer. Decrease input voltage and decrease output voltage. It's that simple.
My son may come over this weekend. He wants to learn how to weld. It takes 2 people to measure the primary and secondary currents..One person to weld and the other to read the amprobes. I may attempt to measure the primary voltage too, measure IR loss.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
