Posted by Tracy Brown on July 03, 2022 at 16:47:51 from (66.211.115.66):
First of all, the engine is in an Allis Chalmers 715 backhoe. I reviewed the Mahle torque specs that Used Red MN attached with his reply. I went with 100 ft lbs with a retorque after a couple of warm up cycles planned. I cleaned and oiled all bolt and (4) nut threads. Then screwed them all down tight by hand. On round one, I took all down to 85 following the recommended sequence. On round two, I took them down to 100. I wasn't satisfied with how they felt at 100 so... Round three I eased them on down to 115 with no retorqued planned now. I reused the (1/2 fine thread) bolts. All looked good. I plan to continue reassembly tomorrow. Thx for all your responses. I'll kp you posted as progress continues.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gettin My Old Tractor Home - by Clayton Sweeney. My name is Clayton Sweeney. I am from Southern Maryland in a small town called Lothian. I am 20 and my father and I are the proud owner of a 1954 Allis Chalmers WD-45. When I was 18, I dated a girl in the next county over. Her family are tobacco farmers. It was a cold Thanksgiving evening, and we were going up to her Grandparents house. As we passed one of their barns, I noticed something orange in the corner of my eye in this old shed. It was pretty dark and I asked what it was
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
