Posted by Tryinmybest on March 26, 2022 at 09:26:13 from (174.207.228.78):
My rail rims ( 5 rails ) are severely rusted and I don't need that type. I already have new tubes and good 14.9 x 28 tires. I have a 1975 Ford 4000 3cyl gas. I don't no which 3L engine I have. It's not a row tractor. This is probably too much information but I have had a heck of a time locating a center wheel that is 28"has a 8 bolt pattern , 8" from bolt center to center with a 5 1/2" center hole. I can find a 6" center hole and it says it also fits a MF. The center hole might be 5 9/16" but it's certainly not 6. Will the 6" work since its bigger or will the extra space make it move. I mean it's going to be bolted to the loop rim and to the axle so will it work. Also the 8 holes look really big compared to the picture of the one I found that might work. I'm going to run it without fluid in the tires because all I do is Bush hog with it.
This post was edited by Tryinmybest on 03/26/2022 at 09:29 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
