Posted by wore out on February 28, 2022 at 21:21:35 from (64.255.159.199):
In Reply to: Cub generator posted by grandpa Love on February 28, 2022 at 17:39:54:
[quote="CVPost-grandpa Love"]
I'm NOT sure why I am taking the time to type this as you likely won't read it through, much less install the generator as I suggest, and give it a try, by here goes...
That specific cutout is rather unique in that it has a field resistor inside similar to the field resistors found on some light switches.
The way the setup is wired NOW is correct for a tractor without a light switch, the "F" terminal on the generator is connected to the "F" terminal on the cutout, making use of the internal field resistor.
(Note the diagram posted by Rodney shows the "F" terminal on the cutout UNUSED, as the light switch is present and it's resistor is used INSTEAD of the one in the cutout.)
All you need to do is connect the BATT terminal on the cutout (the one with nothing currently connected to it) to the tractor's Ammeter and on to the battery and (if the generator and cutout are functional) it will charge at a low rate, just fine for a tractor with no lights.
Polarize the generator BEFORE startup by momentarily jumpering the BATT and ARM terminals on the cutout.
This is a "third brush generator" and the charging rate (with the field resistor in the circuit) is fine-tuned by the position of the third brush.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
