I would wager the filter has never been changed. I drove quite a bit before I went after that filter it did not seam to bother the air flow I did not run the blower after it had to be better.
Nope the leaves do not self clean : ( This is one of my pet peeves when I open the hood customers will rake it out on my shop floor GRRRRRRR I make a big deal out of that so they will remember it... A customer did that one time on a 2000 Buick 3.8 FWD some must have fell between the engine and fire wall when they got home it caught fire and burnt to the ground. Plastic fuel lines feed the fuel rail they run on the fire wall.
In most cases I would have been held liable for that, She took it in stride because I made a big deal out of it and turned it in on her insurance. I now go behind them and make sure none fell on the exhaust manifold.
If y'all have noticed my shop floors are oil/dirt free I don't care who you are I make a bid deal out of it if you trash them. Its not hard to work clean once you get use to it, it becomes second nature. All the help I have hired its hard to train them to clean up the mess they make. I guess they have worked knee deep in speedy dry and walked in the fluids everywhere they have worked they think nothing of it.
This industry has some bad perceptions to change it a clean shop is a good place to start.
This post was edited by Hobo,NC on 02/27/2022 at 06:17 am.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
