Posted by 1939farmall on February 06, 2022 at 10:13:24 from (172.56.13.53):
We ended up with a little over a foot of snow from the storm this week. Not unheard of around here, but not a common occurrence either. I had the Case 830 you guys helped me tune up parked in front of the shop ready to go. I think it did a good job opening the driveway up. It ran great! Its a nice sunny day so I decided to spend some time in the shop. I brought the car up and parked it before the storm hit since it wont get much use till we get a melt! It needs a bath but Ill wait on that for awhile. Some of you might remember when me and son got the auction M going I was having trouble with the starter. I tried to solder it but I really couldnt control the heat and didnt do a very good job. It lasted for a bit but I let the smoke out of it the other day. I order a new one from this site and put it on. Now it cranks like it should! My grandfathers old section of harrow finally broke so I decided to try to fix it up a bit. My dad was my go to guy for welding. Now that hes gone Im bound and determined to become a competent welder! I figured this would be a good piece to practice on. I welded the front up and then used an old bolt in the back and welded it in to reinforce the weld. Well see if it holds! I too embarrassed by my welding ability at this point to show a close up, but Im learning! As I look around the shop I realize how many things you all have helped me with! I like to thank you and tell you all I appreciate it! Thank for spending some time in the shop with us!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
