Posted by electro on December 02, 2021 at 13:32:29 from (206.74.76.168):
In Reply to: Electric motor wiring posted by Bkpigs on November 30, 2021 at 08:37:48:
Not so fast in thanking me. The wiring terminal numbers I posted is correct, however, I do not think the terminal numbers correspond to the wire colors I posted. I do not believe the terminal numbers on that motor are standard. Normally there would be 1,4 as the run windings and 5,8 as the start. They used 1,4 as the run and 2,3 as the start windings and that fits with the label. But the colors I posted do not fit with normal motor standards. Typically the run winding colors would be blue and yellow as numbers 1,4. The start windings would be black and red as 2,3.
If you go by actual standard wire colors then L1, blue, black together and L2, yellow, red. To reverse direction just switch red and black. I believe the label is referring to the wire colors from a specific application going to the motor rather than the internal wire colors. There should be continuity between blue and yellow as the run winding. There may be continuity between red and black as the start capacitor charges.
What I posted previously is correct for the label but I don't believe the label is correct for the actual internal wire colors. check with an ohm meter to be sure but I now believe the run windings are blue,yellow and the start windings are red,black.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
