Posted by electro on December 02, 2021 at 07:38:13 from (206.74.76.168):
In Reply to: Electric motor wiring posted by Bkpigs on November 30, 2021 at 08:37:48:
The diagram on the motor seems clear. The left side is just an example of how it was wired, in this case, CW. (1 to 2) and (3 to 4), those two groups also get L1 and L2. For CCW (1 to 3) and (2 to 4) form two groups and each of the groups get a line input. So L1 to the (1 to 3) group and L2 to the (2 to 4) group. I believe the left part of the wiring diagram is just an example as to how it was wired from the factory.
What is not clear, at least to me, is the photo of the actual wires. Where are the wires coming from? Which are the motor wires and which are the line inputs? There appears to be large yellow, black, blue, and red wires. Are they from the BX conduit on the side? If so, why 4 wires for 120 volts? Was there some type of reversing switch at the other end of the BX conduit? Either way, I would just wire it according to the diagram and see which direction it will run. The worst that will happen is it will trip a breaker but if you wire it according to the diagram most likely it will run just fine.
It also appears to be a capacitor start motor since the one photo shows what looks like the case for the capacitor. However it could be a PSC motor but still nothing bad should happen when wired according to the diagram.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
