As for the 1X6 white cedar you bought, you may of wanted 1X6, but the lumber yard only had 5/8 so thats what they sold you. White cedar probably something they didn't carry. But had some extra 5/8 laying around that they special ordered in for somebody else, and they didn't buy it all. Sold you the extra. Explains why they didn't have any left when you tried to by more. Band saws don't turn as much wood into sawdust as a circular blade. Don't leave the circular saw marks neither. Just some fant vertical marks that don't take much to plane off. I'm sure band saws are set up to cut thinner lumber to accommodate for this. End product being the same as if cut by circular blade. There is a difference in finished thickness for finished on one side, and finished on two. A very long time ago, rough cut meant that a 2X4 was really cut down to 2X4 and left rough and sold that way. If you tear down a very old building and salvage the lumber, you'll run into studs that are true 2X4s and rough cut. That was before the days of expensing the customers for the saw dust of milling, and selling the void and reduced dementions to the customer. If you or the lumbar yard go straight to the source (being the sawmill), you can special order/buy any demention you want.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
