Posted by SVcummins on October 15, 2021 at 19:21:11 from (75.174.164.49):
In Reply to: Tripped plow part 3 posted by Paul Shuler on October 15, 2021 at 17:20:07:
I would probably park it where you can soak the bolt with your favorite penetrating oil as long as its not wd 40 and give it a good soaking every few days . Never understood why ih didnt put a grease zerk in that bolt like John Deere did on their plow . That plow is a good plow and the trip mechanism is pretty simple on it . The parts for it are extremely expensive the latch is almost 200$ last I checked then the leave springs are about 20$ each there are 3 usually from the factory you can add more then there is the special bolt that holds the leaf springs . Its nothing to hit a big rock and brake a latch a couple Leaf springs and brake the special bolt do that a few times and it gets spendy quick . I have a feeling your not probably doing a lot of plowing with it and probably not that many rocks .
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
