Posted by fixerupper on July 14, 2021 at 13:33:09 from (100.42.82.64):
DRussel's post with the video of the high clearance tractor brought back memories of the scariest machine I have ever driven.
My neighbor bought an old Hagie high clearance sprayer 50 miles away and he asked me to go along with him to drive it up on the trailer. He has an artificial leg and because of a surgery could not wear the leg so he was not able to climb on the sprayer to drive it up on the trailer himself.
I had never driven a high boy in my life and to top it off I had never driven a machine with a hydrostatic transmission and this machine had a hydrostat. The boom on this sprayer is on the back and of course the tank that hung down between the wheels was empty. Before I climbed up the ladder to get on my neighbor told me this machine could tip up on it's tail end when the tank is empty! Well thanks for telling me this pal!! Those old Hagies had a frame that was built to flex a bit so when it is driven it wiggles and flexes somewhat. Well I climbed up on it and sat down in the seat. The engine is behind the driver so all I could hear was that engine and all the while the only thought going through my mind was I am going to go over backward and die. I grabbed the hydrostat lever but being a rookie I had no feel for it and when the front wheels went up the ramp with the frame twisting and squirming away and I was looking at the sky from what seemed like twenty feet off the ground I was pretty sure I was going to be going back home in a pine box. Oh did I tell you it didn't have brakes? Well I made it up the ramps and onto the trailer OK but I had some unforgettable moments there.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
