Tractor Talk Discussion Board |
Re: No till vs min till, so far
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave from MN on June 13, 2007 at 07:21:04 from (67.133.91.236):
In Reply to: Re: No till vs min till, so far posted by jus kikin on June 13, 2007 at 05:56:16:
Well, the manure was pretty light compared to previous owner, he spread the whole barnfull on 1/4 of an 80 every 4 years rotating 1/4's. The trash wheels on renters planter cleaned a good 6" in the row. I really wish that was my corn rather than his. Also I noticed there are alot of area where the weeds were so thick that the corn in them weeds is real sickly looking and in some places just died off. It has since been hit with round up and I am starting to see bare spots in the feild. I am concerned about the hill along the pond, no corn, either geese ate it all or was too dry to germinate. I am tempted to see if he will let me drag some rye seed in or something. I hate to see what will happen if we get some of that rain alot of you are getting. I dug down a foot in a few places and that soil is like concrete down there. I am really contemplating ( for next spring) spread the manures, plow it in 6-8", seed it with a cover crop right away for erosion control, then plant the beans and corn right into the rye, and then spray down the rye before it hurts the corn, should help with soil compaction and weed control , as well as moisture retention, does any one agree. I'll be small time, but I want to make some money and be good to the soil.
Replies:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|