Probably OK for light digging in the summer. I rented a little hoe one winter 40 years ago during a hard freeze where the line froze and broke at 3 feet deep. That little hoe wouldn't make a dent in frozen clay.
Bot a 2606 with IH 3000 loader and Case CK 33 hoe. It will do the work. Can't wait to get it back together. The loader had heavy mounts that went back to the axle. Then the hoe had heavier mounts that tied into the axle and then underneath to tie into the loader frame further forward.
It has a solid mount. Assuming your 3 point will lift it, I'd be more worried about driving around on rough ground with all that weight moving around working on the top link mount. When digging with the stabilizer arms down then I would worry so much.
What you need to know is if your tractor has enough hydraulic gpm's to dig with those big cylinders. You can be running the swing, boom, and bucket cylinders all at the same time to do any efficient digging. Those little ones can dig around a stump but may not have the power to pull out a stump that doesn't have all the roots cut.
I'm rigging up a knife setup on mine with a couple cutter bars at a V to pull pipe instead of having to dig a 15" hole for water lines. If the kids are over you can always mount a basketball goal on the bucket and park it on the driveway to make it useful.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
