Posted by avant 1735 on March 18, 2021 at 14:29:00 from (99.197.120.193):
Working on ford Jubilee, it has been setting for many years, did and in frame, engine runs good. Hooked it to a 5ft shredder and lifted the shredder, I heard a clatter. My first thought was push rods sure sounded like it, but then we lowered the shredder and the clatter stopped, did this a few more times with the same result. I am assuming the hydraulic pump is shot. All the fluids have been drained and replaced, not too long ago. Also there is a small plate below the seat, towards the right side and front of the seat, it has 5 bolts in it, hydraulic fluid was leaking from underneath the plate. I was going to unbolt it apply some sealer then bolt the plate back. Is there anything I need to watch for when removing the plate? Would y'all agree the pump Is the issue? if not any suggestions would be greatly appreciated. Thank you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.