Good Moring sv, Sorry I don't have any data as to the longevity and maintenance cost and that sure would have to be included in any economic analysis. If its NOT feasible I WOULD NOTTTTTTTT invest (and recommend others not) UNLESS it was still worth it to me to be totally self sufficient if I was off grid or wanted to be ready if the grid went down AND THATS PRICELSS FOR SOME WHO SO CHOOSE.
Hey I cant make anyone else's decision or have any cost figures for maintenance and longevity, each have to make THEIR own analysis and decision based on THEIR NEEDS AND PRIORITIES AND FINANCES.
Great question sv, sorry I don't have the answers, it would take time to study and research all that so to each their own choices for whatever THEIR reasons may be, Im sure NOT going to tell them how to choose and spend their money, thats THEIR CHOICE
Best wishes, God Bless, study and research and make a wise informed decision that suits YOU and others should do the same
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
