Posted by Jim.ME on February 10, 2021 at 15:38:12 from (67.242.178.40):
In Reply to: 1970 MF150 posted by quade365 on February 08, 2021 at 13:35:54:
Quoting Removed, click Modern View to see
To be clear, I think you mean you are replacing the stock oil filter, that has a replaceable element in a reusable housing (can), with a spin-on filter adapter kit so you can use a spin-on filter, similar to a filter most car use?
You don't say where you are located. I use 15W/40 diesel oil year round. The 135 with the AG3.152 holds 6 quarts without filter change and 6.5 quarts with filter change. I would put 5 quarts in and check the dipstick, then fill to the full mark, run it a few minutes, shut it down, let it set a few minutes, and check it again. Changing the filter set up may change the quantity it takes. So have at least 7 quarts available when you start.
You really need to get yourself a 150 Operator's manual and a 150 service manual. Get Massey Ferguson manuals first, not I&T ones because you can get one cheaper. I&T ones fill in some things, but not best as primary manuals. JMHO
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
