Posted by wore out on January 31, 2021 at 09:08:16 from (64.255.159.199):
In Reply to: John Deere MT timing posted by Moultonk on January 31, 2021 at 08:26:20:
Quoting Removed, click Modern View to see
"1. What cylinder is 1 and what is 2"
#1 is in front, nearest the radiator, like almost every other tractor.
"2. How do I know if the cam shaft is timed right camshaft gear spins once to the crankshafts two rotations so its either right on or 180 off"
No different than any other other 4-cycle engine.
Align the crank gear marks. (If you turn the crank one turn the marks will be 180 off, turn the crankshaft one more turn and they again will line up. NOTHING to worry about.)
There's any number of places to buy a generic shop manual on the 'net, you must not have looked real hard, this very site has them, or look on ebay for an original DEERE manual (SM2001 and SM 2002, the MT supplement) (the best there is) or buy them direct from DEERE Techpubs by calling 1-800-522-7448.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
