Posted by bc on January 18, 2021 at 20:39:49 from (24.255.129.137):
In Reply to: Cheap screw drivers posted by svcummins on January 18, 2021 at 19:25:12:
Quoting Removed, click Modern View to see
The problem originated in Canada. Peter Roberston of Robertson Screw Co. invented it based upon a British design and patented it in Canada in 1907. It was used at Henry Ford's Windsor, Ontario auto plants. Ford wanted to use it at his American plants but Robertson was stubborn and he refused. Then John Thompson redesigned it and got an American patent in 1933 and 1934. He couldn't get anyone to use it so he sold it to Henry Phillips in 1935 who redesigned Thompson's and got a new American patent. In 1936 Phillips got General Motors and everyone else to use it in the US. So then we end up with differing designs being used with the Phillips in America and the Robertson screw in Canada and also adopted by Japan which has become a problem today. The Robertson screw is faster and has less cam-out (will tighten up without twisting out of the thread). However American manufacturers wanted more cam-out so they had less chance of being over tightened during the manufacturing process. Go figure. So even though a screw and screwdriver may be labeled Phillips, it may or may not be.
As an aside, I use nothing but Torx head T-25 screws now.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
