Posted by K Effective on January 02, 2021 at 06:29:33 from (99.184.108.123):
In Reply to: silly question?? posted by venuschild1968 on January 01, 2021 at 15:07:27:
Rest assured, there are no silly questions. There is a ton of experience here, so your questions may seem silly to some, but to you, they are your reality.
I would start the tractor with the cap removed and let it run at mid idle, watching the fluid in the radiator. Put an empty bucket under the radiator just in case it does overflow. Once you see a change in the flow in the radiator, or air being released, or if the liquid swells and seems constant, just install the cap carefully or shut it off and let it cool first.
A stuck-closed thermostat would cause the motor to heat higher quickly without transferring the heat to the radiator, not likely to cause your summer issues. A stuck-open thermostat will allow coolant flow to the radiator all the time, thus cooling more than you would want, also not causing your summer issue.
But a system not holding pressure, due to a leak, will boil at a lower temperature than a pressurized system, especially one with below-average coolant mix. That sounds like your summer issue, and should be found with a pressure test tool, which you can rent for free from O'Reilley and AutoZone.
Unfortunately, coolant can leak in weird places on a 50-year-old tractor. Look for signs of water in your oil or hydraulic fluid, usually a milky white/tan goo on the dipstick or cap.
Lots of these guys have far more experience with your specific tractor than I, and I'm always willing to learn from them. Well, most of them, that is...
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
