Doesn't matter, It would be common sense to NOT leave a mess in the road that is hazardous. If you must push across a road clean up your windrows and don't leave hazards. How hard is that to understand ? Apparently very difficult for some. Either do it in a safe manner or find another way. If society needs laws to control things like this, people just don't have a drop of common sense anymore.
I have a rental property directly adjacent to a busy state road, tempting to push out and across the road, too dangerous. There is another way. I have in the past done this when clearing a neighbors short road, but always cleaned up the windrows and left nothing in the road. Honestly, it's more work to push across a road, whereas if on your property it may not have to be cleaned 100%.
It's no different than cutting grass, people enthusiastically point the discharge side of the mower deck towards the road, leave all the clippings onto the pavement and often times shoot small stones, dirt and dust right at passing vehicles. I was riding with a friend in a new truck and an old timer cutting the grass along the road, put a nice ding in his door with the mower. When confronted about it, he just shrugs it off, literally like who cares, why are you bothering me with this? He could easily go the other way. Doesn't take much intelligence to determine you should run the opposite direction and or wait for clearing in traffic if you must run that way. Leaving the clippings in the road, how foolish and selfish is that, I mean really..... but this is the mentality of some, it makes no sense at all.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
