Posted by 07AKU on December 16, 2020 at 18:14:14 from (118.209.76.165):
In Reply to: Second hand parts posted by 07AKU on December 14, 2020 at 21:29:35:
Still cant post images.. It would be so much easier that way.
Now I can, as said build up and turn down buuut just because I can doesn't mean I should?
Lots of general questions like do I "need" all those wheel bolts, I was given advice (and not taken :lol:) to run my drive wheels with only 50% of the mounting hardware. The requirement for this machine regardless of make or model is to be as reliable as possible as it will be doing hundreds of hours of work thousands of dollars from the nearest workshop and I don't fancy having to leave my machine in the middle of a "swamp" for another few years while I track down parts (if they happen to be "the wrong parts" that break) or God Forbid, need an air lift, or worse yet a pine box because of a failure.
What sorts of metal are old mounting studs like this made from?
I mean my good bolts still have casting flash on them which in my limited experience is a good sign I cant weld it to a standard to which I would trust my life or the life of others against I do have 2 "practice" or "spare" bolts because I always over-order due to paranoia and 'they don't make 'em anymore" factor so I can do very limited testing but have no idea how to really.
I am just a man with a lathe a welder and a tractor and just enough knowledge to get neck deep in trouble.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Diesel Vs. Gasoline - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: " I am in the market for an older tractor (to be read... cheap). I have been told a diesel holds up better than a gasoline engine as far a wear, tear, neglect and abuse. Since I am looking at older tractors that have probably been through it all, is it better to buy diesel? I do expect to have to do a good bit of work on
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
