Posted by rustred on September 01, 2020 at 20:20:03 from (74.214.153.210):
ok so here is the hyd. filter it had in it. changes that went back to field and did some discing.very little improvement. still hesitates when letting clutch out. tales 2-3 seconds then jumps ahead. then went back to yard and added more oil so its overfull. not much difference. when i pull TA back the light comes on. something really crazy going on. it never seams to do the same thing. sometime light stays on and tractor wont move and the next time it goes out pretty much as clutch is released . the next time it will go out and jump ahead. it also appears with higher rpm the light seams to do its thing better. this last time in field at high rpm the light started flickering and tractor started jerking as in clutch slipping. they say these are a mechanical clutch so how can the tractor be jerking ? i am thinking there must be some o rings in mcvalve body screwed up as by the looks of that filter this tractor had poor maintenance. plus it sat for 45 years not used. this makes me really like my 660 now.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
ok so here is the hyd. filter it had in it. changes that went back to field and did some discing.very little improvement. still hesitates when letting clutch out. tales 2-3 seconds then jumps ahead. then went back to yard and added more oil so its overfull. not much difference. when i pull TA back the light comes on. something really crazy going on. it never seams to do the same thing. sometime light stays on and tractor wont move and the next time it goes out pretty much as clutch is released . the next time it will go out and jump ahead. it also appears with higher rpm the light seams to do its thing better. this last time in field at high rpm the light started flickering and tractor started jerking as in clutch slipping. they say these are a mechanical clutch so how can the tractor be jerking ? i am thinking there must be some o rings in mcvalve body screwed up as by the looks of that filter this tractor had poor maintenance. plus it sat for 45 years not used. this makes me really like my 660 now. 