Posted by LarrySTN on August 19, 2020 at 19:53:36 from (166.216.159.173):
In Reply to: Re: 4240 Jd Hydraulics posted by Bruce SEKs on August 19, 2020 at 19:26:17:
The stroke control valve is what controls the hydraulic pressure in the hydraulic pump of your 4240. If you are not familiar with it I would suggest finding someone who is. The stroke control valve can be removed by removing a plug with a set screw and jamb nut from the under side of the pump. This plug is in the control head of the pump and not one of the radial plugs in the pump body. With the plug, spring and valve removed, a very very brief engine start and shut off and then reinstallation of the plug should put you back in business. There is also a possibility the stroke control spring is broken. The brief engine start is to flush any debris out of the valve bore that may have caused the valve to hang up.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.