Posted by Mike M on August 06, 2020 at 08:45:48 from (24.140.3.214):
In Reply to: Hard plowing posted by tomstractorsandtoys on August 06, 2020 at 08:01:22:
Well it will separate the ones with good equipment who know how to set it from those that don't ! lol. I went to a plow day once and the field was hard and had been pack down from the silage wagons going back and forth too. A guy with a 730 transmission went out so I hooked my 720D onto his 4 bottom full mounted plow and it went really good. I was worried as I had no extra weights but that plow was set up good and had new parts and it went well. My JD LA and 1 bottom mounted plow I had to stop and unbolt the front hitch and tilt it down for more down force and then it went really good too. One other time in easy plowing ground I had my late B and hooked onto a 2 bottom trailer plow. It was not going too well and I could see the plow was trying to go crooked. They had a 3 bottom plow there so I hook to it and was able to go fine. Just had to down shift going up the grade on the backside of the field.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.