Posted by jon f mn on April 16, 2020 at 04:03:12 from (174.219.27.166):
In Reply to: Re: Welding question posted by marcusmerritt on April 15, 2020 at 18:10:44:
7014 is for flat clean welds. It's a drag rod so you tap the rid on the metal and drag it along as apposed to raising it to create the arc. That makes it very easy to use and get a good bead. It would be a good rid for this. 6011 is the old standby and an excellent rod. It does handle dirty metal better and penetrate better. With your welder being taxed for this the extra penetration might be helpful. However, a good weld with any rod is better than a poor weld with any rod. 6011 is harder to use than either 7014 or 6013 so therefore be careful. Most will say 6013 is not as good but it's easier to use than 6011 and can be used in all positions. The truth is that very few people on this site have either the skills or equipment to make use of the differences in rods, so choose the one that works best for you and go to work.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
