Posted by greg oliver on March 15, 2020 at 07:22:15 from (72.173.89.183):
In Reply to: Update on hay field posted by Grandpa love on March 15, 2020 at 06:30:09:
Sounds like a better deal for sure on the 4 acres. I like to just use my tractors a little as I’m the one that’s got to fix them. We rented some farm land in 1987 that was 16 miles one way. My dad would drive over and mow I would run over in the afternoon and pick him up. No cell phones how did we survive? Made about 450 round bales and brought them back 5 at a time. Had an old 8 x 30 house trailer still had the wooden floor and no lights or brakes. He nailed a board on with an SMV sign. I was riding with him and a NYS trooper follows us I was ready to crawl under the seat . Never pulled us over I said to my dad he didn’t pull us over because he was going to get writers cramp in his hand! Lol
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
