Posted by Mnethercutt on November 10, 2019 at 11:27:15 from (45.24.163.50):
Still chasing carb problems on my John Deere 1010. Was browsing ebay when I discovered the aluminum carbs for Ford tractors (8N's, Jubilees) that are selling for around 50 dollars, and noticed they look very similar to my TSX-809. Bottom line would that work? I know the linkage is a little different, but I measured the dimensions they list on ebay and the dimensions of my carb and it's almost dead on. Maybe 1 or 2 millimeters off but no more than that. At this point its been a year since the tractor has run right and I'd be ok with just slapping that aluminum carb on if it would be simpler than tearing down a carb i've been thru 8 times. So, would it work, or am I just grasping at air here?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Roof Palomino - Tractor or Jeep? - by Steve Nelson. My father-in-law purchased this jeep-like lawn mower back in 1968. He says he paid $1600.00 for it, which was big bucks back then for a mower. My own father bought a VW bug the same year for the same price. Well it
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
