Posted by MTC on November 01, 2019 at 18:31:44 from (207.190.97.76):
I would guess a lot of you have this problem. I have been doing shots for 3 years now and am 69 years old. I have the wet kind. For the heck of it I asked for a break down of cost for this visit every 10 weeks. Before I tell you the cost I am very greatful it is holding my eye sight and not getting worse. I also get the more expensive Eylea drug --2mg in each eye. The nurses prep me about 10 minutes and Dr does injection, See him about 1 minute. He likes to do about 35 injections a day. My bill for the injections is -----10,300.00 every 10 weeks. I can not believe it. Between medicare and my supplemental insurance it cost me nothing but still. Medicare and my supplement insurance pay about 4600.00 of the 10,300.00 bill. Hospital says OK.I still cannot believe what gets billed. Thoughts
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
