|
Tractor Talk Discussion Board |
Re: JD R injector system bleeding
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don Wadge on December 30, 2001 at 18:55:01 from (24.66.94.141):
In Reply to: JD R injector system bleeding posted by Jim Compton on December 30, 2001 at 09:13:03:
This is a fairly simple procedure and in my experience a sure thing as long as you have fuel to the supply pump and filters are not plugged. First of all remove the check ball from the fuel supply pump. (Some of the earlier R's had a by-pass on the sediment bowl housing the later one's did not.) To avoid confusion I think you can just leave the by-pass (if you have it) in the run position. On the bottom of the fuel supply pump you will find a flat nut (plug) which takes a 3/4 or 7/8 wrench. Turn this out until it is loose but do not pull it away quickly. In here you will find a spring and on top of the spring a small( 3/16" ) check ball. Remove both of these and put the plug back in. Next remove the bleed plug in the first filter and leave it out until fuel runs from the hole then put it back in and remove the plug on the second filter. Wait for fuel to run and replace. Then remove the 3rd plug which is above the second plug and wait for fuel to run and replace the plug. If the filters were sucked dry it could take several minutes for fuel to run from the first filter. Now replace the check ball and spring. Now try starting the tractor- I will start on the second or third stroke. Never ever have to bleed injectors on a two-banger. If by any chance you have done all this including the check-ball; make sure you have fuel running freely from the out port of the pump with the check-ball removed. This is the procedure, if it doesn't work you have another problem. In that case email me. Good luck. Let us know what happens.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|