Posted by RichS on July 18, 2019 at 05:06:35 from (67.143.192.7):
In Reply to: Stump grinders posted by vapet on July 17, 2019 at 11:21:55:
I have a Miller Pro-150, needs 75-150 hp, 1000 rpm PTO, 3 remotes, weights 2370lbs, 30 inch cutting wheel. Takes longer to move to stump and position (Minutes) than to get rid of stump. Hydraulic positioning of cutting disc with swing, lift, and telescoping functions, all controlled from the tractor. Cuts up to 36" stumps without repositioning. Pine stumps up to 30" takes 1-2 minutes to grind 10" below ground level. Old oak stump, cut for a year or two takes 3-4 minutes, green oak takes a little longer. Have ground 400-500 stumps, in East Texas edge of the Piney woods. This is a stump eating machine.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
