Tractor Talk Discussion Board |
Re: Electrical problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on December 08, 2001 at 17:45:25 from (66.66.72.246):
In Reply to: Electrical problem posted by Grizz on December 08, 2001 at 16:55:48:
Hey Grizz - The same thing happened to me last weekend. Problem turned out to be a bad terminal (battery post clamp). Suggest removing the clamp and THOROUGHLY cleaning the inside down to bright metal all around (use a rat tail file). Also thoroughly clean the battery post, then clamp the terminal down good and tight. Chances are you will have solved your problem. (If the terminal clamp and clamp bolt are at all suspect, recommend replacing with a new one.)
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|