Posted by dhermesc on June 28, 2019 at 16:09:01 from (24.248.193.103):
In Reply to: Re: Towing a baler posted by Tx Jim on June 28, 2019 at 05:15:57:
I did it old school with a 7' wide trailer. Let one side drop on the baler's frame with the wheel hanging over the edge then took the tire off on the knotter side to make it sit lower and boomed it down tight. The knotter side weighed about 3X what the pickup side weighed and the trailer didn't trail worth a d****. Top speed was 45 - but without the trailer it probably would have been about 25 mph.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farming Never Left My Blood - by Stan Gordon. I was born in 1947 youngest of ten of a working farm. Our farm was located in Saskatchewan near Saskatoon. We had a mixed farm consisting of grain and dairy all done with old machinery and by hand. My dad had a tractor, a Farmall A which was used mostly to run the thrashing machine, a seed drill and for plowing. I remember locals used to help each other and threshing was done from daylight to after dark, one farm to another until all farms were done.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
