I am going to buy a metal cutting blade for my circular saw.
In the front and back (gable ends) I am going to use a fresh sheet for each top piece and only cut the angle top. This will be covered by flashing so I am not to worried about these pieces.
On the sides I will wait and see how the metal looks after cutting with this saw blade because this is where I will have exposed cuts.
I like the idea you gave me of using clear sheets at the top to let in light. But on the other hand I was planning to put 1 sheet of OSB under the metal on each corner for wind bracing. I'm thinking of putting 2 pieces of metal in the front and back to cover the OSB and using the clear sheets in the middle. This will give me a 2 foot by 12 foot sky light on each side of the building.
Worst case scenario I will need to buy 16 pieces 2 foot long (about $75) and then all exposed cuts will be factory cuts.
I am not worried about the exposed cuts as far as looks go. My main concern is cutting the panels efficiently and the integrity of the metal after cut. A little rust color on the edge is one thing; but rusting to the point of jeopardizing integrity is different.
Point is case..... I drove 70 miles one way to get .80 CCA wood for the post rather than buying pressure treated wood locally. I am building this shed for my great grand kids; not just me.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
