|
Tractor Talk Discussion Board |
Re: Re: 8n runs rough and smokes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on November 25, 2001 at 16:34:31 from (209.23.132.16):
In Reply to: Re: 8n runs rough and smokes posted by jakee on November 23, 2001 at 20:39:41:
Thanks for the tips. I did mic the cylinder walls (top/bottom and same at 90degrees) All measurements were within .003 of being in spec. The cylinder walls were honed before installing the new piston rings. The gap of the piston rings was checked before the rings were put on the pistons and all were not more that a .010 gap.
Still trying to figure this out. Dont know if the rough running is a differant problem from the oil on the cylinde top or not.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
